Asada Beaver 4Eco, Instruction Manual

Page: 5 / 28

5
-Always use the machine at the voltage indicated on Machine Plate.
Otherwise, the machine may become hot, emit smoke or catch fire.
-At cutting do not force the machine in a manner that the motor stops due to an
overload switch.
-Immediately replace the Power Plug, Power Cord and extension cord, if damaged.
-If the machine has emitted smoke or took fire, do not disassemble it but have it
inspected or repaired by a qualified person.
-Never install an earth wire to the gas pipe.If attempted, explosion may take place.
-Do not use the machine in the presence of flammable liquids or gases such as
gasoline and thinner. Otherwise, ignition or explosion may take place.
-The machine and other parts coast for a while after the switch is turned off.
Never touch them while they are moving.
-Cut surfaces are very sharp and do not touch them with your hands.
-When it is required to touch the saw blade and moving parts for replacement, etc.,
switch off the machine and unplug it before starting that operation.
-Always ground the machine to avoid electric shock or resultant death.
-Do not touch the plug with wet hands.
-Do not expose the machine to rain and water and do not use it in damp or wet
locations.Humidity will deteriorate motor insulation or lead to electric shock.
-Immediately replace Power Plug, Power Cord or extension cord, if damaged.
-Do not hold the Power Cord and pull it to disconnect from the receptacle and do
not put the machine on the cord and damage it.
-An extension cord used should be a three-core cabtyre cable having an earth wire.
Use a thick and durable cord for outdoor use.
-Before plugging the machine in, always make sure that the switch is OFF. If the
machine remains plugged in, it will start suddenly, leading to unexpected accident
or injury.
-During operation, keep your hands and face away from the moving parts. You may
be caught in the moving parts, causing injury.
-Do not use gloves for works such as cutting. You may be caught in the moving
parts, causing injury.
-Do not wear neckties, open-sleeved clothing, knitted gloves, loose clothing or
jewelry (such as necklaces). Otherwise, you may get caught in moving parts.
-Wear caps or protective hair covering to contain long hair. Otherwise, you may get
caught in moving parts.
-When not in use or when servicing, cleaning, checking or replacing parts, switch
off and unplug the machine. If the machine remains plugged in, it will start suddenly,
leading to accident or injury.
-Do not leave the machine unattended during rotating. Others may get caught in
moving parts.
-It is mandatory to use Pipe Support for long and heavy work to avoid shaking and
distortion of the work during turning and tilting of the machine by the weight of the
workpiece. Otherwise, the workpiece and the machine become unstable.
-Wear safety glasses while operating the machine. Chips enter your eyes and nose.
-Do not blow off chips using compressed air. They may get into your eyes and loss
of eyesight may result.
-Use a face or dust mask if operation creates dust. Sawdust and dirt may enter your
eyes and nose.
-Immediately after cutting, fragment are hot. Do not touch them directly with hands.
-When lifting the machine, bend your knees to avoid a load on your waist.
-The machine with chip is slippery. Do not drop the machine on your feet while
lifting it.
-Do not install the machine inclined or on an unstable place. The machine fall down,
causing injury.