Asada Beaver 4Eco, Instruction Manual

Page: 15 / 28

15
3.OPERATION
The following gives a general description of work including the pipe cutting.
(1)Prepare for operation.
(2)Install the work on this machine.
(3)Cutting the pipe.
(4)Remove the cut pipe.
The following describes the contents of the above procedures.
1)Preparing for Operation
-Before adjustment work, always disconnect the power cord.
The machine may start suddenly, leading to injury.
-When opening the front cover, guard against the saw blade which may spring out
of the machine.
-After correct setting of the saw blade to the machine, always close the front cover.
You may get injured when the saw blade is broken or comes off.
-Fix with the latch after confirming the front cover is correctly set.
Causes the accident and the injury, damaging latch when the cutting work is done with
front cover not correctly set.
-It is mandatory to use Pipe Support for long and heavy work to avoid shaking and
distortion of the work during turning and tilting of the machine by the weight of the
workpiece. Otherwise, the workpiece and the machine become unstable.
-Saw blade is very sharp. Do not touch with bare hand.
(4)Unlatch the front cover and open the cover. Turn the tension handle clockwise. The saw blade will be tight.
[ Fig.3 , 4 ]
(5)Hand-turn the saw blade to make sure that it turns.
(6)After reinstall the front cover, tighten the fasteners.
(7)Insert the power supply cord after confirming the thing to which the switch is off.
Fig.3 Fig.4
Tighten
Loosen