Asada Beaver 4Eco, Instruction Manual

Page: 14 / 28

14
3.OPERATION
The following gives a general description of work including the pipe cutting.
(1)Prepare for operation.
(2)Install the work on this machine.
(3)Cutting the pipe.
(4)Remove the cut pipe.
The following describes the contents of the above procedures.
1)Preparing for Operation
-The saw blade selected should have T.P.I. which matches the workpiece.
For saw blade selection, refer to the cutting load chart on the machine or in the instruction manual.
-Operate the machine in the cutting load position which matches the workpiece.
A mismatch in the T.P.I. of the saw blade or in the cutting load position will lead not only to oblique cutting
capability but also to a damaged saw blade.
-Do not turn on the switch with the saw blade being put on the workpiece.
Otherwise, the tool can fail.
-When starting cutting, ease the saw blade down to the workpiece after the saw
blade has fully rotated.
Do not hurry it down or force it in to avoid a tool failure.
(1)Remove sand, the soil, chips, and dust, etc. on its vise.
(Wipe off for the new article with a clean cloth because the rust prevention oil has painted the upper surface
of stock vise)
(2)Raise the frame and set the cutting load adjustment knob in a position which matches the workpiece as
indicated in the cutting load chart.
(For cutting load adjustment, push down the cutting load adjustment knob and set the pin in the groove
position.) [ Fig.1 , 2 ]
Cutting load
adjustment knob
Fig.2 Fig.1