Asada Beaver 4Eco, Instruction Manual

Page: 17 / 28

17
2)Setting the Workpiece(Flat Vise Type)
3)Cutting
4)Removing the Workpiece
-Ease the saw blade toward a workpiece.
Do not hurry it down or force it in to avoid a machine failure, accident or injury.
-When a new saw blade is used, test cuts are required as it is liable to cut obliquely.
Cut a workpiece once or twice at the cutting load position “1”.
-Immediately after cutting, fragment are hot. Do not touch them directly with hands.
Wait for a while or hold the pipe with a cloth. Otherwise you may get burned.
(1) Put the workpiece on the vise sureface in a secure condition.
. Because of the rapid feed mechanism, hold down the feed
screw guide and push the clamp handwheel toward the
workpiece. [ Fig.6 ]
. Release your finger from the feed screw guide and turn the
handwheel to clamp the workpiece.
* For beveling, loosen the two bolts in the jaw (R), set it to the
cutting angle on the scale, and tighten the bolts.
(1) To release the stopper, hold the grip, lift the frame, and turn on the switch.
(2) After making sure that the saw blade rotates steadily, lower the frame slowly to put the saw blade onto
the workpiece.
* For miter cutting, support the frame Handle by hand until the saw blade bits the workpiece slightly.
(3) At the end of cutting, the machine switches off automatically.
(1)After cutting ends,removing the workpiece.
*The quickly loosened can be done by separating Flat Vise-F from workpiece after clamp handle is loosened.
Feed Screw Guide
Fig.6