DDM200 user manual - hardware
Created by: MPuchner 01.2020
version: 9600024A
Original user manual
page 29 of 66
printed: 25.02.2020
Before drilling holes you should mark the hole positions on the concrete with a permanent marker. In case the
base plate moves during the drilling process you can align the plate again then. Drill the 8 holes with a 10mm
rock drill. The depth of the drill holes must be at least 120mm. Use a vacuum cleaner to remove bore dust
during and after the drilling process.
Caution: Wear appropriate protective gear such as safety goggles and ear protection!
Figure 26 - drilling holes for concrete screws
Once all the holes are drilled fix the base plate with the included concrete screws and washers.
Figure 27 - concrete screws
