Mounting the attachments
16
Mounting the attachments
The attachments are mounted on the stud bolts of the front of
the attachment carrier.
2
3
1
4
Preparing the attachment carrier for the
attachment
The stud bolts (
1
) can be fitted in two positions on the bolt-on
plate (
4
). Depending on the position other attachments from
AS-Motor can be fitted.
1. To loosen the stud bolts, screw both nuts (
2
) onto one
stud bolt.
2. Tighten the nuts against each other (lock).
3. Unscrew the stud bolt with the rear nut.
4. Insert the stud bolt in the appropriate position.
5. Tighten the stud bolt with the front nut as far as it will go.
6. Repeat steps 1-5 with the second stud bolt.
Attachment
Inner
position
Outer
position
ESM cutter bar G90900102
-
x
LOSI cutter bar G90900103
x
-
Attachment flail bar G90900104
x
-
Attachment sweeping brush
G90900105
x
x
Mounting the attachment
6
5
Notice
Risk of damage due to incorrect mounting of the attach-
ment.
► When mounting, make sure that you do not damage the
threads.
1. Place the attachment carrier on the support leg.
When doing so, ensure the correct height setting. The
coupling flange on the attachment (
5
) and the bolt-onplate
of the attachment carrier (
4
) must be at the same height
and parallel to each other.
2. Remove the nuts (
2
) and the washers (
3
).
3. Push the attachments with the coupling flange carefully
onto the stud bolts (
1
).
4. Screw the washers (
3
) with the nuts (
2
).
5. When screwing on, make sure that the centring ring (
6
)
slides into the bolt-on plate (
4
) and that the coupling
flange (
5
) lies flat against the bolt-on plate.
The claw coupling slides back when it is screwed on and en-
gages during operation.
Dismounting the attachment
1. Remove the nuts (
2
) and the washers (
3
).
2. Remove the attachment.
3. Screw the nuts (
2
) and the washers (
3
)onto the stud bolts.