5.5. Glide
When the Glide knob is set to a non-zero value the pitch sweeps from one note to the next.
The maximum glide time is 10 seconds. Set the Glide knob 100% to the left to disable glide.
There are several ways to define the glide behavior (time vs. rate, smooth or quantized, etc.).
To access that page, hold [Settings] and turn the Glide knob. The options are described in
5.5.1. Glide in Split mode
When PolyBrute is in Split mode the glide setting is shared between the two zones. But since
Split mode assigns the A+B morphing feature to the upper zone, independent glide times
are possible: sound A glide time can be zero, and sound B glide time can be non-zero (or
vice-versa).
5.6. Morph knob
The Morph knob lets you morph manually between sounds A + B. Its position is visible in
each mode (Presets, Mod, Sequencer, and Morph): when the knob is turned, a graphic on
the left side of the display goes up and down.
The current position of the Morph knob is stored with the patch, and that becomes the
starting point for the morph mods. For more information, see the
.
5.7. Ribbon controller
That smooth groove in the front panel provides a unique way of controlling a sound. It's
like a cross between a paint brush and the fingerboard of a violin; you can add color by
touching the surface and then sliding or trilling. Use it to unlock your own "smooth groove".
As with other controls, hold [Settings] and touch the ribbon to access its settings page. Then
configure as desired: Should modulation start from where your finger lands, or jump to a
certain value based on ribbon dimensions and the modulation amount? Should the mod
level return to zero when released or stay where it was? It's up to you. These settings are
stored with the patch, so the ribbon can work differently for different situations as needed.
40
Arturia - User Manual PolyBrute - Performance Controls
Summary of Contents for PolyBrute
Page 1: ...USER MANUAL...
