MAT-8000
9
11. gAIN
The Zone Gain control will set the
maximum Source Output Volume Level
for the Zone.
This will ensure the user cannot adjust
the Audio Level too high using the Master, MIC1 and
Music Level Control Knobs on the Front Panel. Gain will
set the Maximum Output Volume of Line Source and
MIC1. It will have no control over the Paging Level.
12. hF
The Zone HF Treble of the Zone Output
can be controlled by adjusting the
HF Treble Level Control.
This Level Control will provide adjust-
ment of the 100Hz AudioFrequency by
10 dB.
Every Zone has a HF Treble Level Control which enables
the HF Treble Level of each zone to be set independently
of other zones.
13. ENABLE/DISABLE SWITCh
If a Zone Remote Wall Control Panel is
to be used with the System, the RJ45
Remote Control Panel Input needs to
be enabled. The RJ45 Remote Control
Panel Input is enabled/disabled by
pressing the Enable / Disable Switch.
Every Zone has an RJ45 Remote Con-
trol Panel Input Enable / Disable Switch.
NOTE: Only Enable when a Zone Remote Wall Control
Panel is connected.
14. REMOTE SOURCE gAIN
The Zone Local Source Input Signal
Level can be adjusted from 190 mV to
200 mV using the Remote Source Gain
control. This will enable the signal
level of all sources to be equalized
there by ensuring Output Volume Level
remains constant when switching from
one source to another source. Every Zone Remote Source
Input has a Gain Control.
15. FIRE ALARM
There are Fire Alarm dry contacts for zones 1-8. When
Dry Contact is detected the EMC Input will be open and
take priority over all other inputs.
The EMC Input will only take priority and broadcast to
zones where there is a Zone Fire Alarm Dry Contact
Closure.Each zone has a separate Fire Alarm Dry Contact.
Fire alarm, alert, EVAC and EMC in are of equivalent
priority.
16. LINE gAIN
The System Line Source Input Signal Levels can be
adjusted from 190mV to 200mV using the Line Source
Input Gain control. This will enable the signal level of all
sources to be equalized there by ensuring Output Volume
Level remains constant when switching from one source
to another source.
All system source inputs L(lines 1-8) have a separate
Gain Control.
17. LINE INpUTS
The system has 4 Line Inputs, as well as 4 inputs
selectable as mic or line with phantom power available.
Every Line Source Input has a dual RCA Phono Connector,
which will enable a Stereo Source Signal to be connected.
Note, however, this is a Mono system and a Stereo Input
will be combined to give a Mono Output.
The Line Inputs have an impedance of 47 K Ohms
1. Line 1-8 source inputs will be selectable using the
Source Select control on the front of the Matrix.
2. The selected source input number will be indicated on
the Matrix zone display.
3. Any extension Matrix unit connected to the system will
use sources line 1-8 from the master Matrix.
4. Only one set of input sources for lines 1-8 can be
connected per system.
18. pAgINg CONSOLE INpUTS
Up to two paging consoles can be con-
nected to the system simultaneously via
the two paging console RJ45 input ports.
The paging consoles will have equal pri-
ority and will operate on a first come first
served basis. The RJ45 pin assignment
order is as below:
Summary of Contents for MAT-8000
Page 15: ......
