12
CONTROL AND CONNECTORS
LEDs system indicators
ETHERNET:
RJ45 network connector. Connect the ERT to your local
network, to open the 2002 port and send AHnet commands to the units
connected to the RS422 ports (AHnet1 and AHnet2).
LED1:
Change the state when an AHnet command is received from the
two RS422 ports (AHnet1 or AHnet2).
LED2:
Change the state when the unit receives data from the local
network port (ETHERNET).
LED3:
Not used.
LED4:
Change the state when the unit send an AHnet command when
the automatic AHnet ID configuration is activated (DIP2). The ERT
interface sends commands to the units connected on AHnet1 and
AHnet2 to automatic configure the AHnet ID on each unit.
RF:
Brigths when a mobile or tablet is connected to the unit to control
and configure the ERT using the AHlink APP.
