Arthrex Synergy AR-9800, User Manual

Page: 56 / 60

Synergy
RF™
User’s Guide
DFU-0221-6r0_fmt_en-US
Page 54 of 58
Table 23 Guidance and Manufacturer's Statement - Electromagnetic Immunity
The AR-9800 Synergy
RF
System is intended for use in the electromagnetic environment specified
below. The customer or the user of the AR-9800 Synergy
RF
System should ensure that it is used
in such an environment.
Immunity test IEC 60601 test level Compliance level Electromagnetic
environment -
guidance
Electrostatic
discharge
(ESD)
IEC 61000-4-2
± 8 kV contact
± 15 kV air ± 8 kV contact
± 15 kV air Floors should be wood,
concrete or ceramic
tile. If floors are
covered with synthetic
material, the relative
humidity should be at
least 30%.
Electrical fast
transient/burst
IEC 61000-4-4
± 2 kV for power
supply lines
± 1 kV for input/output
lines
100khz Cycling
Frequency
± 2 kV for power
supply lines
± 1 kV for input/output
lines
100khz Cycling
Frequency
Mains power quality
should be that of a
typical commercial or
hospital environment.
Surge
IEC 61000-4-5
± 1 kV line(s) to line(s)
± 2 kV line(s) to earth
± 1 kV line(s) to line(s)
± 2 kV line(s) to earth
Mains power quality
should be that of a
typical commercial or
hospital environment.
Voltage dips,
short
interruptions
and voltage
variations on
power supply
input lines
IEC 61000-4-11
Uτ = 0%, 0.5 cycle
(0,45,90,135,180,225,270
and 315º)
Uτ = 0%, 1 cycle
Uτ = 70%; 25/30 cycles
(@ 0 degrees)
Uτ = 0%; 250/300 cycles
(
Uτ = 0%, 0.5 cycle
(0,45,90,135,180,225,270
and 315º)
Uτ = 0%, 1 cycle
Uτ = 70%; 25/30 cycles
(@ 0 degrees)
Uτ = 0%; 250/300 cycles
Mains power quality
should be that of a
typical commercial or
hospital environment.
If the AR-9800
Synergy
RF
System
requires continued
operation during
power mains
interruptions, it is
recommended that the
AR-9800 Synergy
RF
System be powered
from an
uninterruptible power
supply.