234B Series TEC TO-Can
LaserMount
U
ser’s Manual
· Page 7
Mounting your device:
Insert the device so that the common pin is the top or
bottom pin, the isolated photodiode pin is on the left, and the isolated laser pin
is on the right. If using a 2-pin style G laser, the laser anode would be to the right
and the laser cathode to the left. The illustrations below show the mounting of a
free-space TO-can laser, but the fiber-pigtailed device would mount in a similar
fashion.
Your pin length must be in the range of 5mm to 9mm; most diodes are 6.25mm.
Longer pins must be trimmed or they will bend when clamping the diode.
No Laser
Laser Loose
Once the device is loaded, for free-space TO-can lasers, use the provided
5.6mm or 9mm diode clip to clamp the TO-can to the temperature-controlled
gold plate. For fiber pigtailed lasers, the panel mount holes will line up with
either the inside (for 5.6mm) or outside (for 9mm) holes, or the top and bottom
holes when mounting vertically housed packages, such as those available from
Thorlabs.
Clip, 1 Screw
Clip, 2 Screws
