Page 14 · 6300 Series
ComboSource
User’s Manual
Mode
Setpoint
Displayed Measurements
Laser
Io
Current (mA)
PD current or power and voltage
Im
PD current (
μ
A) Current
and
voltage
Po
PD power (mW)
Current and voltage
Vf
Voltage (V)
Current and PD current or power
TEC
T
Temperature (°C)
Temperature, current and voltage
R
Sensor (k
Ω, mV, uA, or Ω)
Sensor, current and voltage
ITE
TEC current (A)
Temperature, current and voltage
The instrument will show photodiode current or photodiode power, depending
on the value of
PD Resp
. Photodiode current is shown whenever
PD Resp
is
zero, while photodiode power will be shown whenever
PD Resp
is non-zero.
See the
Laser
or
TEC Control Modes
sections below for more information on the
various modes.
Status Messages
The instrument will display status messages in upper right corner indicating
several different conditions for the laser that may be of interest to the user. If
multiple conditions exist simultaneously, then the instrument will cycle through
each condition, displaying each status message for approximately one second.
Possible laser condition messages are:
LoBW
The unit is in Io (LoBW) mode.
HiBW
The unit is in Io (HiBW) mode.
Script
The unit is executing a script or remote command.
Lock
The interlock is open and the unit cannot be turned on.
Shrt
A short circuit has been detected on the output.
ILim
The unit is in current limit.
MLim
The unit is in photodiode current limit.
PLim
The unit is in photodiode power limit.
Notice that LoBW and HiBW mode indicators are in reverse text, and are used to
highlight the operating mode.
Summary of Contents for ComboSource 6300 Series
Page 1: ......