Parts Needed For
Ridge Caps 12x17, 12x24 & 12x31
Step 24
BW35
7828 Middle Roof Panel (see below)
7843 Ridge Cap (see below)
7827 Left Roof Panel (1)
6874 Ridge Cap (1)
8
STEP
STEP
IF YOU ARE BUILDING A 12x24 (3,7 m x 7,3 m)
Replace ridge cap 6874 with an additional
ridge cap 7843 and install ridge cap 6874 to
rear of building.
IF YOU ARE BUILDING A 12x31 (3,7 m x 9,4 m)
Replace ridge cap 6874 with 2 additional ridge
caps 7843 and install ridge cap 6874 to rear
of building.
1
Continue weather stripping and
fastening overlaps.
2
Position a ridge cap 7843 on the
completed front roof section.
3
Install 2 middle roof panels.
4
Install the second ridge cap 7843
overlapping the fi rst ridge cap. Align
the holes and fasten using bolts.
5
Temporarily remove right rear roof
panel. Install 4 middle roof panels.
As each panel is fastened, carefully
raise 2nd ridge cap slightly away from
panels for fasteners and tape.
6
Install the right and left roof
panels at the rear gables. Follow
fastener sequence.
7
Install the third ridge cap 6874
overlapping the second ridge cap.
Align the holes and fasten using
bolts.
8
Fasten the lower end of the
panels to the side top angle using
screws.
3
STEP
6
STEP
1
STEP
4
STEP
2
STEP
7
STEP
5
(3,7 m x 5,2 m / 3,7 m x 7,3 m / 3,7 m x 9,4 m)
Do not fasten
this end
Do not fasten
this end
6874
Weather Stripping
#10-32x7/16"
(11 mm) Bolt
7843
Weather Stripping
#8Ax5/16" (8 mm) Screw
#10-32 Square Nut
7828
7827
7843
37
