The rear fl oor frame is made up of 2
pieces. The holes in these pieces will
align when the pieces are positioned
with correct amount of overlap. The
illustration below shows the proper
overall length for the rear.
1
Overlap right and left rear frames,
align holes, and fasten using 8 bolts
and nuts. Make 3 assemblies. Use
1 assembly for this step.
2
Position floor frames as shown
and fasten at each corner using 2
bolts through the bottom and nuts
on top. When installing side frame
7914, be sure set of holes 1" (2,5 cm)
in from end of frames are installed
toward rear of building.
3
Fasten side frames together with a
truss support using 4 bolts through
the bottom and nuts on top.
Step 5
BW17
8532 Right Rear Frame (1)
8531 Left Rear Frame (1)
7914 Side Frame (see below)
7857 Truss Support (see below)
#10-32 Square Nut
#10-32x7/16" (11 mm) Bolt
IF YOU ARE BUILDING A 12x24
(3,7 m x 7,3 m)
Fasten additional side frame 7914 and
truss support 7857 to side frame 7914
using the side connection. Position rear
frame at rear of assembly and fasten
using the rear corner connection.
IF YOU ARE BUILDING A 12x31
(3,7 m x 9,4 m)
Fasten 2 additional side frames 7914
and truss supports 7857 to side frame
7914 using the side connection. Positon
rear frame at rear of assembly and fasten
using the rear corner connection.
4
Measure the fl oor frame diago-
nally. When the measurements are
equal, the fl oor frame is square.
5
Select location of side door on
either side, toward the rear of build-
ing. Install lower door track and
ramp, notch toward outside, using
1/4" (6 mm) bolts and nuts. See
Step 12 for Rear Door Installation.
7834
Position with small holes
toward outside of building
FRONT
#10-32x1/4" (6 mm) Bolt
STEP
4
STEP
1
NOTE
Do not fasten the fl oor frames
to your foundation at this time.
You will anchor the building
after it is erected.
The fl oor frame must be square
and level or holes will not align.
7837 Side Frame (2)
7834 Right Front Frame (1)
7835 Left Front Frame (1)
7517 Lower Door Track (1)
7560 Ramp (1)
7837
7857
7517
7835
7837
7914
7857
7837
7914
STEP
3
STEP
2
Rear Frame 140 7/8"
357,8 cm
Slot
Notch toward outside
of building
8531
8532
8531
8532
Level
7560
7914
7560
Side Frame
7517
SIDE
REAR
7857
NOTE
Position of holes, and fasten at
the 1st set of holes. See side
connection.
STEP
5
Level
Parts Needed For
Floor Frame Assembly
12x17, 12x24 & 12x31
(3,7 m x 5,2 m / 3,7 m x 7,3 m / 3,7 m x 9,4 m)
1"
2,5 cm
19
