第
8
页 共
18
页
脚架安装 Landing gear installation
1.将机身中控上保护盖拆除，将机身翻转（图 1）
1. Remove the protective cover on the middle
control and turn the fuselage over (Figure 1
2. 机身底部朝上，将底部脚架固定座拆开（图 2）
2. The bottom of the frame is facing upwards,
and the bottom landing gear fixed part is
disassembled (Figure 2)
3.将脚架对准机身底部固定座，请务必注意脚架安装在机身左右两侧（图 3/4）
3. Align the landing gear to the bottom of the frame, please be sure to install the landing gear
on the left and right sides of the frame (Figure 3/4
）
4.安装 M3*16 螺丝，首先无需螺丝完全紧固，只起到固定作用（图 4），再将机身翻转（图 5），将脚架调
整平衡后再拧紧螺丝，注意脚架固定末端需要抵到电池仓。.Install M3 * 16 screws. First, they do not need
to be fully tightened. They only serve for fixing (Figure 4), then turn the body over (Figure 5). Adjust
the balance of the landing gear and tighten the screws. Note that the fixed end of the landing gear
requires Arrive in the battery compartment.
