第
15
页 共
18
页
此时进行电机调平，需要将上碳板安装完毕、机臂完全展开，再进行校准，使用水平仪校准电机与机臂水
平，拧紧四颗 M4*14 固定螺丝。
At this time, to level the motor, you need to install the upper carbon plate and fully extend the arm, and then
perform calibration. Use a spirit level to calibrate the level of the motor and the arm.
摄像头安装，遥控器为：思翼 AK28 Camera installation, remote control: Siyi AK28
安装摄像头转接板，使用 M2*8 螺丝将转接板固定于摄像头背面，并安装于 U 型侧板前方。
Install the camera adapter plate, use M2 * 8 screws to fix the adapter plate on the back of the camera, and
install it in front of the U-shaped side plate.
摄像头的线束走向为穿过 U 型侧板预留孔，穿过主碳管臂，与接收机相连
The camera
’
s wiring harness is reserved for passing through the U-shaped side plate, through the main
carbon tube arm, and connected to the receiver.
注意：动力及飞控安装完毕后，需按照拆卸顺序将上碳板、鲨鱼鳍、中控上盖安装完成。
Note: After the motor and flight control are installed, the upper carbon plate, shark fin, and central control upper
cover must be installed in the order of removal.
