第
12
页 共
18
页
飞控安装 Flight control installation
This manual is equipped with
Flight Control of JIYI K++
, matching
Hobbywing X6 motor set
seat tube diameter 40mm, Fengying T12 remote control. Note that all power supply voltages of
the distribution board are 12S, and the circuits are connected in parallel.
1、拧松四颗 M3*8 螺丝，拆下 GPS 安装板
1. Loosen four M3 * 8 screws and remove the
GPS mounting plate
2、拧松 M3*32 铜柱，拆下两块飞控预留安装板
GPS 安 装 板 2. Loosen the M3 * 32 copper
pillars, and remove the two flight control
reserved mounting plates and GPS mounting
plates.
本手册配置极翼 K++飞控、匹配好盈 X8 电机座管径 40mm，风迎 T12 遥控器。注意分电板所有电
源电压为 12S，并联电路。
示意图 Flight control
installation diagram
1、将飞控主体使用 3M 胶或其他固定方式安装在飞控安装板，注意飞控方向
1. Mount the flight control body on the flight control mounting plate using 3M glue or other fixing methods,
pay attention to the direction of the flight control
