ARPLAST PV-50, Manual

Page: 59 / 60

Page 7 of 8 © Lyndhurst Touchdown Services Limited updated February 2007
In order that we can provide a better service to future customers and perhaps to you in the future it would
be helpful if you could tell us a much about your installation as possible. Please keep a copy fro your own
records. This could help you set up your installation if the propeller is ever damaged.
Name:
Email address:
Tel #
Propeller Type:
Arplast PV50 serial # ........... Diameter … cm Narrow/Wide Blade Form
Engine Type:
Rotax ……………………..…
Aircraft Type:
……………………………………………….
Maximum pitch measured at ¾ diameter
……………………..
Minimum pitch measured at ¾ diameter
……………………..
Maximum rpm at minimum pitch measured with the aircraft stationary (tethered) …………………. rpm
Please provide as much additional information below as you wish
Pitch RPM Fuel
consumption
IAS FL Temp TAS
Pitch should be given as degrees measured on the back of the blade at ¾ diameter. (That is ¾ the
distance from the centre of the propeller to the tip or ¼ from the tip in. For a 160cm propeller measure
20cm in from the tip! You can use an angle finder placed on the blade when it is in a horizontal position
with the A/C level.
Please post or fax the form to LTS – 64 Wellands Rd, Lyndhurst, SO43 7AD