Ariston Fi7 16L FF, Service Manual

Page: 56 / 57

Technical Manual for DGI
- 56 -
02 Non-conforming air source Change another air source
03 Seizure of fan Adjust or replace
04 Seizure of anti-downdraft device Adjust or replace
05 Creekage of ignition needle Adjust or replace
06 Ignition distance is too large Adjust or replace
07
Ignition distance is too small
Adjust
08 Lagging of ignition Replace
09
Flame row near ignition needle is blocked
Clean or replace
10 Nozzles near ignition needle are blocked Clean
11 Flue pipe is blocked Clean or replace
12 Re-installation
Improper installation: insufficient oxygen
supply
99 Other causes Other causes
01
Bad connection between signal wire and
main control board or wire controller
Re-plug in
02 Signal wire is too long Re-adjust
03
Cross section area of signal wire is too
small
Re-adjust
04 Fault of signal wire Replace or repair
05 Fault of operation panel Replace or repair
06
Fault of wire controller
Replace
07
Fault of wireless remote controller:
overlarge operation distance or too many
face walls, or there’s no code for emitter or
unsuccessful code and “E9” is displayed
Re-adjust
08
Fault of wireless remote controller:
：
Displayed contents is incomplete
Replace the wireless
remote controller
09
Wireless remote controller runs out of
electric power
Replace the No. 7 batteries
10 Wireless remote controller PCB is damaged
11 Fault of main control board
Replace the main control
board
DGI
communication
fault "E8"
99 Other causes Other causes
01
Water leakage between external water pipe
and water supply connector
Adjust/replace seal ring
Water leakage
02
Water leakage between external water pipe
and water outlet connector
Adjust/replace seal ring