Argo-Hytos EL7-I Series, Instruction Manual

Page: 17 / 60

EL7-I_Pokyny_Instructions_Hinweise_19151_1en_de_cz_04/2021
Page 17
www.argo-hytos.com
- appears by clicking the Enter icon in the bottom bar or by dragging from left to right
(Android only)
Device name
- serves to better identify the electronics in the device.
It is possible to enter a name with a maximum
of 32 arbitrary characters.
Password
- enables the changing of the default password to
another.
The password can contain any characters, the maximum
length of the password is 16 characters, case sensitive.
Bluetooth
- the option deactivates the Bluetooth module, the application is disconnected an it will no
longer be possible to reconnect to the electronics. The blue LED will turn off and flash.
To re-connect it is necessary to press the “Configuration button“ inside the electronics. The
blue LED will start flashing showing it is possible to connect. Bluetoth activated in this way
will be active for 10 minutes, connection is possible during this time. For permanent
commisioning, it is necessary to set the switch in the application to “Bluetooth permanently
enabled“ otherwise the module will be deactivated again within 10 minutes after disconnec-
ting the application.
Disabled Bluetooth is enabled by briefly pressing the ”Configuration button“ it is then possible to connect to the electronics.
Enabling Bluetooth by pressing the button lasts 10 minutes, Bluetooth is then deactivated and the button must be pressed
again for further activation.
Permanent activation must be performed in the EL7_mobile application by selecting “Bluetooth permenently enabled“.
Bluetooth is not activated when the EL7_mobile application is active.
See page 5 for access and location of the „ Configuration button “
Attention!
The button is located directly on the electronics motherboard, use a non-conductive object to press the button.
Any contact of a conductive object with the electronics board around the button, can damage or destroy the electronics.
Attention!
By removing the lid, the electronics lose primary protection against moisture and dirt, it is necessary to ensure that neither
mositure nor dirt get inside during use of the “
Configuration button “. Leave the lid removed only for the necessary
length of time and refit as soon as possible.
Attention!
There is a seal around the perimeter of the lid and under the screw, which must remain intact after removal and return of
the lid on the electronics and the rim surfaces must be clean. Otherwise, the seal will not perform its function properly,
moisture and dirt may enter the electronics and cause destruction.
7.4.5 System setting