Original User Manual
–
A
REBO
S SPA Pool
25
pipe and run some water through the filter inlet
hole and outlet hole. This should remove any
limescale or debris. Use a net to collect and
remove any loose particles.
6. Turn the hot tub back on (without the filter
to test the hot tub is functioning)
–
Press SET Temp and key in your desired
temperature
–
Press ‘set Temp’ and Press ‘Heat’
7. Place on the top cover
Once completed
–
Leave the hot tub running for
a couple of hours, the water temperature
should start to rise.
The control panel
is showing a high
temperature
reading.
- Possibly due to the small
amount of residual water
(a maximum of 300ml)
surrounding the heating
element, which is where
the temperature sensor is
located
–
therefore
displaying a reading that
will not be reflecting the
actual water
temperature.
- usually due to a
blockage caused by either
limescale build up, a dirty
filter or a seized impellor.
- Activate your filter to allow the water to
circulate inside your hot tub.
- Turn on the air jets for a few minutes to
disperse any pockets of warm water.
- Turn off the hot tub at the mains to reset it.
Leave for 30 minutes to allow the heating
element to cool.
- Carry out the following steps for the below 3
points, as instructed on the
HL Error Code
Troubleshooting guid
e to ensure that there is
no blockage.
–
Limescale build up.
–
Dirty filter
–
Seized impellor
For more frequently asked questions or more help, please scan me:
