Original User Manual
–
A
REBO
S SPA Pool
23
Error Code messages:
Error Code: HL
- there is a blockage,
preventing water from
circulating around the
pump & heating system.
The blockage can be
caused by a dirty filter, a
blocked impellor or
limescale build up
–
especially if you live in an
area with hard water.
This will cause a higher
temperature reading
being recorded than the
temperature set.
Check water flow:
Check the flow of water from the filter outlet by
placing your hand 6-8 inches away from the
outlet. You should feel the water flowing
through the outlet valve.
If the flow rate is weak or non-existence or your
pool is making a grinding noise, please follow
the steps as follow:
1)
Ensure your filter is clean and doesn’t
need replacing.
2)
The Filter cover should be rinsed under
a tap to clean thoroughly.
3)
make sure the filter is not
overtightened.
If you have tried above, and your spa is not
heated. please carry out following steps:
1. Turn off the heater and filter.
2. Remove the Filter cover and Filter.
3. Place the filter cover over the filter inlet and
use an elastic band to hold the filter cover in
place (to stop debris getting into the pump)
4. Press the ‘Heater’ button on and reset the
temperature.
5. If the temperature begins to rise and
maintains its temperature it is likely that your
filter needs a replacing.
Impellor Blockage or Debris
If a hot tub is used without a filter, or debris has
been drawn into the motor it may cause the
impeller within the water pump to seize.
We advise following the below steps to check
for problems.
1. Turn off the hot tub at the mains.
2. Drain the water from the hot tub.
3. Remove the filter and protective filter cover.
4. Perform a visual check of the outlet inside
and out
–
check for anything that maybe
obstructing the water flow.
Limescale Blockage
Many areas have hard water, causing limescale
build up within home devices. We recommend
you to conduct a descaling routine into your hot
tub maintenance schedule:
1. Turn off the hot tub at the mains.
2. Remove the Filter and protective cover.
3. Place your garden hose pipe against the filter
inlet hole and outlet holes.
