Original User Manual
–
A
REBO
S SPA Pool
15
4.2.2 BUBBLE button
•
ON/OFF button for the jet system.
•
Press this button and the jet system starts to work and the red indicator lamp lights up. The
jet system stops automatically after 20 minutes of operation. If there is still a need, wait 10
minutes and then press the BUBBLE button again.
•
Air jets can be stopped or started again at any time during the 20-minute cycle.
4.2.3 HEATER button
•
ON/OFF button for the heating system.
•
Press this button and the heating system starts working and the red indicator LED lights up.
At the same time, the red light of the Filter button lights and the filter pump starts working.
This is normal because heating is not possible without the filter pump.
•
To switch off the heating system, press the HEATER button again and the red indicator lamp
goes out.
•
When the pre-set temperature has been reached, the heating system stops working, while
the heating indicator light stays on. At the same time, the filter pump keeps working.
o
When the water temperature drops below the pre-set temperature, the heating
system and filter pump will start working again. The filter control LED comes on
again.
o
If the heating system does not restart automatically, switch off both the heating
system and the filter pump by pressing the “HEATER” and “FILTER” buttons and both
red indicator lights go out.
•
Important!
Always install the cover firmly on the spa after use to minimize heat loss
when heating the water for good heat insulation. Store the cover in a suitable place
where it is free from contamination or damage.
•
Note:
The integrated temperature sensor works with an accuracy of +/- 2°C.
Depending on the set water temperature, it may therefore be the case that the
heater / pump does not switch on immediately but with a delay. This is not a
malfunction.
•
Note:
If the ambient temperature is below 10 ° C, the heater works slower than
normal. All SPA functions are blocked at am ambient temperature below 0°C.
Operating the heating system or other functions at sub-zero temperatures can cause
irreversible damage to water pipes and electrical components inside the motor block.
4.2.4 SET TEMP button
•
Temperature setting button.
•
The current water temperature is displayed on the screen.
•
Press the SET TEMP button and the numbers on the screen will start to flash. To set the
desired temperature, press the corresponding arrow button.
TEMP UP: button to increase the temperature.
TEMP DOWN: button for lowering the temperature.
•
The temperature can be adjusted within the range 20-40°C.
•
When you have adjusted the temperature, press the TEMPERATURE button again to confirm
the new setting.
•
Note:
It may take between 12 and 24 hours before the water has heated up to the required
temperature. The ambient temperature and the temperature of the mains water affect how
long it takes for the water to be heated up. The water temperature drops every time when
the heater is switched off on the SPA. please wait some time for the water to warm up
before using the SPA next time.
