Original User Manual
–
A
REBO
S SPA Pool
24
4. Run clean water through the system, helping
to remove any debris or loose limescale.
5. Use a net to collect and eliminate any loose
particles from the water.
6. To reduce the effects of limescale build up
ensure that water descaler is used weekly to
prevent scale formation and build up
If you have carried out all steps above, and the
problem still persists, please contact the
customer service team who can arrange a
repair.
Error Code: SH
- Malfunction of the
circuit board or the
temperature
sensor.
Please contact our customer service Team so
that we can arrange a repair.
Error Code: FC
The filtration system has
worked for approx. 168
hours advising you to
check your filter. The
pump & heating buttons
will be disabled.
–
Make sure the filter is clean and change if
necessary.
-
Press ‘Filter’ button & the FC Error code will
disappear. The water temperature will be
displayed and all the functions will return to
normal.
Error Code: SL
- Blocked or dirty Filter
- Low Ambient
Temperature. When the
weather is cold, the SL
code may appear. This is
most likely due to the
pipe and heater being too
cold to function.
–
Make sure the filter is clean and change if
necessary.
- Pouring some hot or warm water into the hot
tub (either using a hot water pipe or buckets of
hot/warm water).
- Pouring some warm water into the top outlet
An explanation to the manual reset button on the outer shell of hot tub:
Explanation
Cause
Solution
When temperature of the
heating element in the
motor block is over 47°C,
the device will stop
heating. This manual
reset button is part of
over-heating protection.
- Press the Manual Reset Button on the pool
after 15-20 mins of waiting time. You will hear a
“click” sound, and try to restart the device.
-
if you don’t hear a “click” sound when pressing
the button or the device fails to restart. please
contact our customer service team.
Other questions that are frequently asked:
Problem
Cause
Solution
The temperature is
not increasing.
- A dirty filter and
limescale can affect the
overall performance and
heating function of your
hot tub.
1. Turn off the hot tub at the Mains socket.
2. Remove RCD Plug from the socket.
3. Wait 10 Seconds then Plug RCD Plug back
into the Mains socket.
4. Remove the Filter and Place the filter sock
over the filter inlet so no debris gets into the
pump/heater
5. Turn the pump off and get your garden hose
