Original User Manual
–
A
REBO
S SPA Pool
16
5.
Cleaning, maintenance and storage
5.1 Draining the water
•
You have the following options to drain the water from the whirlpool.
•
Method 1:
Turn off the power.
Let a submersible pump into the whirlpool and use it to pump out the water.
Do not reconnect the pool to the power supply until it is filled with water.
•
Method 2:
Turn off the power.
Unscrew the end cap of the water outlet located below on the filter heating element of the
whirlpool and screw on the filling hose.
Then pull off the plastic plug on the inside. Now the water can flow out.
When the spa is out of water, press the BUBBLE button for 2-3 minutes to drain the water in
the air line.
When the water is completely drained, remove the filling hose and close both outlets again.
•
Caution!
The drained water can contain chemical residues and/or other unhygienic
components, that can have a negative impact on health and the environment. Check
your local authority regulations to find out how you can safely and responsibly
dispose of the waste water.
To prevent the growth of undesirable bacteria, make sure there is no more water in
the pool.
5.2 Filter cartridge
•
For optimum performance of your hot tub, check and clean the filter cartridge after each use
of the SPA to remove any small particles and residue.
•
To continue to enjoy your hot tub. we suggest you to have 2-3 filter cartridges available.
•
Change the filter cartridge every 3 days. The same applies if the SPA is not used for several
days. The filter cartridge should be regularly cleaned or removed for the period of non-use,
as the addition of chemicals could cause the paper of the filter cartridge to flocculate.
