7-6
MD2381
6. Place the hub assembly onto the spindle; then
install the washer and castle nut. Tighten the castle
nut to 45 ft-lb; then install a new cotter pin. Install
the wheel and tighten the cap screws to 30 ft-lb.
7. Remove the ATV from the support stand.
Swing Arm
REMOVING
1. Secure the ATV on a support stand to elevate the
rear wheels; then remove the wheels.
2. Remove two cap screws securing the brake caliper
to the axle housing.
KM207
3. Remove drive chain, hubs, spacers, and axle as
necessary (see Rear Hub/Drive Axle in Section 6).
NOTE: Do not remove more components than
necessary to perform the intended service. The
axle housing will separate from the swing arm with
all components attached if necessary.
4. Remove the four cap screws (A) securing the axle
housing to the swing arm; then remove the axle
housing.
KM217B
KM212A
5. Remove the cap screws securing the skid plate and
rear chain guard; then remove the skid plate and
rear chain guard.
MD2014
6. Remove the cap screw securing the shock absorber
to the swing arm.
! WARNING
After removing and installing components that are
brake-related, ALWAYS check and adjust brakes as
necessary before operating the ATV.
! WARNING
Make sure the ATV is solidly supported on the support
stand to avoid injury.
Back to TOC
Back to Section TOC
Next
Back
FOR ARCTIC CAT ATV DISCOUNT PARTS CALL 606-678-9623 OR 606-561-4983
www.mymowerparts.com
