50
Headlight HI/LO
Switch
CF245A
Use the headlight HI/LO switch to
select the high or low headlight beam
when the ignition switch is in the
LIGHTS position. When the switch is
in the HI position, the high beam will
illuminate. When the switch is in the
LO position, the low beam will illumi-
nate.
Emergency Stop
Switch
OFF position — The ignition circuit is
off. The engine cannot be started or
will not run. If the emergency stop
switch is used to stop engine without
turning off ignition switch, the battery
may discharge.
RUN position — The ignition circuit is
on. The engine can start and run.
Electric Starter Button
Pushing in on this button activates the
starter motor. Before starting the
engine, make sure the ignition switch is
in the ON position, the transmission is
in neutral, the reverse shift lever is in
the forward position, and the brake
lever lock is engaged.
NOTE: This ATV has safety inter-
lock switches which prevent the
starter motor from activating when
the transmission is not in neutral
or when the reverse shift lever is in
the reverse position. To start the
ATV while in gear, depress the aux-
iliary brake pedal or compress the
brake lever; then depress the
starter button.
Reverse Override
Switch
These ATV’s are equipped with a
reverse speed limiter system. When
additional RPM is needed in reverse,
depress and hold the override switch.
Throttle Lever
FI475B
Control engine RPM with the position
of the throttle lever. Operate this lever
with the thumb. Pushing it forward
increases engine RPM and allowing it
to retract decreases engine RPM.
! WARNING
Never activate the override switch
while the throttle is open as a loss
of control may result.
Summary of Contents for 650 H1 2010
Page 82: ...80 NOTES...
Page 91: ...89 MAINTENANCE RECORD DATE MILEAGE SERVICE PERFORMED NOTES...
Page 92: ...90 MAINTENANCE RECORD DATE MILEAGE SERVICE PERFORMED NOTES...
Page 94: ...92 NOTES...
