54
CARBURETOR FLOAT
BOWL DRAIN
AF925
Periodically, the float bowl should be
drained to remove condensation. To
drain the float bowl, use the following
procedure.
1. Direct the float bowl drain hose
into a container.
2. Loosen the drain screw and allow
the gasoline and condensation to
flow out.
3. Tighten the drain screw securely.
OIL LEVEL STICK
ATV-0100AA
There is an oil level stick for checking
the engine oil level. To check the oil
level, use the following procedure.
NOTE: The ATV should be on
level ground when checking the
engine oil level.
1. Unscrew the oil level stick and
wipe it with a clean cloth.
2. Install the oil level stick until the
threads touch the engine case.
3. Remove the oil level stick; the
engine oil level should be above
the “L” mark but not higher than
the “F” mark.
SEAT LATCH
AL676A
1. To remove the seat, lift up on the
latch release (located at the rear of
the seat); then raise the rear of the
seat and slide it rearward.
2. To lock the seat into position, slide
the front of the seat into the seat
retainers and push down firmly on
the rear of seat. The seat should
automatically lock into position.
! WARNING
Do not drain float bowl contents
directly onto the engine. Gasoline
is highly flammable and could
ignite. Use a hose.
! WARNING
It is very important that the drain
screw be tightened securely. If it is
not tightened securely, gasoline
could drip onto the engine.
CAUTION
Do not overfill the engine with oil.
Always make sure the oil level is
above the “L” mark but not higher
than the “F” mark.
Summary of Contents for 650 H1 2010
Page 82: ...80 NOTES...
Page 91: ...89 MAINTENANCE RECORD DATE MILEAGE SERVICE PERFORMED NOTES...
Page 92: ...90 MAINTENANCE RECORD DATE MILEAGE SERVICE PERFORMED NOTES...
Page 94: ...92 NOTES...
