Arctic Cat 650 H1 2010, Operator'S Manual

Page: 78 / 96

76
ATV-0070

NOTE: There should be an aver-
age operating load on the ATV
when adjusting the headlight aim.
2. Measure the distance from the
floor to the mid-point of each
headlight.
3. Using the measurements obtained
in step 2, make horizontal marks
on the aiming surface.
4. Make vertical marks which inter-
sect the horizontal marks on the
aiming surface directly in front of
the headlights.
5. Switch on the lights. Make sure
the HIGH beam is on. DO NOT
USE LOW BEAM.
6. Observe each headlight beam aim.
Proper aim is when the most
intense beam is centered on the
vertical mark 5 cm (2 in.) below
the horizontal mark on the aiming
surface.
7. Adjust each headlight until correct
aim is obtained by turning the
knob clockwise to raise or counter-
clockwise to lower the beam.
CD714A
FUSES
The fuses are located in a power distri-
bution module under the seat. If there
is any type of electrical system failure,
always check the fuses first.

NOTE: To remove the fuse, com-
press the locking tabs on either
side of the fuse cover and lift out.
1411-502
ELECTRICAL OUTPUT
TERMINALS
Two output terminals for electrical
accessories are located on the front and
rear wiring harnesses. The accessory
plug is located on the instrument pod.
STORAGE
COMPARTMENT/
TOOLS
A basic tool kit is provided with the
ATV. Maintain the tool kit with the
ATV at all times.
CAUTION
Always replace a blown fuse with a
fuse of the same type and rating. If
the new fuse blows after a short
period of use, consult an autho-
rized Arctic Cat ATV dealer imme-
diately.
CAUTION
Always use electrical accessories
less than 180W.