Arctic Cat 500 Sno Pro, Operator'S/Performance Manual

Page: 42 / 95

36
IO039A
8. Loosen the clamp and remove the gasline hose
from the delivery pipe of the throttle body assem-
bly.
IO040A

NOTE: At this time, clamp or close off the gasline
hose; then secure the hoses, throttle cable, and
wiring harness out of the way.
9. Loosen the clamp and remove the throttle body
coolant hose; then loosen the clamps securing the
throttle body assembly to the intake flanges.
Remove the throttle body assembly out the MAG-
side of the engine and secure the assembly up and
out of the way.
IO041A

NOTE: The intake boot must be compressed
enough to allow room to move the throttle body
assembly forward and out of the intake flanges.
IO042
10. Remove the clamp from the vent hose; then loosen
the clamps of the cylinder head coolant hoses and
remove the hoses. Remove the two coolant hoses
from the elbow fittings of the crankcase located
below the exhaust ports.
IO044A
IO045A
11. Remove the E-ring; then loosen the jam nuts of the
oil-injection cable. Remove the cable from the oil
pump and account for the nylon washer.
CAUTION
Since the fuel supply hose may be under pressure,
remove it slowly to release the pressure. Place absor-
bent towel around the connection to absorb fuel.