31
WS041A
8. Install the wheel; then using a crisscross pattern,
tighten the wheel nuts in 20 ft-lb increments to a
final torque of 40 ft-lb (steel wheel), 60 ft-lb (alumi-
num wheel w/black nuts), or 80 ft-lb (aluminum
wheel w/chrome nuts).
9. Remove the vehicle from the support stand.
Front Wheel Alignment
NOTE: All measurements and adjustments must be
made with the vehicle unloaded.
NOTE: Make sure the white alignment marks of the
steering rack are aligned.
WT080A
Mark the center-line of the front tires at the front and rear
of the tire; then using a tape measure, measure and record
the distance between the marks at the front and rear. The
front measurement should be 3-6 mm (1/8-1/4 in.)
greater than the rear measurement (toe-out).
WT292A
To adjust the wheel alignment, use the following proce-
dure:
1. Center the steering rack; then using an open-end
wrench to hold the tie rod (B), loosen the right-side
and left-side jam nuts (A).
WS009A
2. Turn the left-side and right-side tie rods (B) in equal
increments to achieve the proper toe-out; then
tighten to 25 ft-lb.
Accelerator Pedal
REMOVING
Dislodge the yellow nylon bushing of the throttle cable
from the actuator arm; then remove two torx-head screws
and nuts securing the accelerator pedal assembly to the
splash panel and remove the accelerator pedal.
WT099C
CAUTION
Always use a wrench to hold the tie rod ends when loos-
ening or tightening the jam nuts or damage to the boots
could occur.