68
ROV1-078A
NOTE: The longer fasteners go in the holes num-
bered one through six.
7. Rotate the engine to right-side up and install the
remaining crankcase cap screws and washers.
Tighten the cap screws (A) to 7 ft-lb and the cap
screw (B) to 21 ft-lb.
KC550A
NOTE: The longer bolt is installed just to the right
of the oil filter.
8. Rotate the engine again and using a twelve-point
socket, tighten the connecting rods to 22 ft-lb, then to
36 ft-lb, and finally to 45 ft-lb.
ROV1-091A
NOTE: Rotating the crankshaft will aid in lining up
the fasteners.
9. Install the oil crossover tube. Tighten to 13.5 ft-lb.
ROV1-092A
NOTE: Verify the correct positioning of the wash-
ers.
10. Place the rubber O-ring into the oil pressure relief
valve bore; then push the oil pressure relief valve
until the O-ring on the valve is past the chamfer.
ROV1-095
ROV1-096
11. Install the oil screen pickup grommet with the flat
side of the rubber facing up; then install the oil
screen so the high side faces the oil filter to make it
level with the oil pan when installed.