88
WT571
6. Using an appropriate press, remove the two bearings.
WT572
7. Using an appropriate press, remove the rubber seal
and mechanical seal as an assembly.
WT570
INSTALLING
1. Apply grease to the inside and outside of the seal;
then press in the rubber seal.
WT576A
2. Using a section of 1” pipe, press in the mechanical
seal.
WT575
3. Individually press in the bearings.
WT573
4. Install the impeller in place and secure with a washer
and E-clip.
5. Install the magneto cover and secure with the cap
screws. Tighten the screws to 11 ft-lb.
6. Install the impeller cover and secure with the cap
screws. Tighten the screws to 11 ft-lb.
NOTE: The two longer cap screws go in the dowel
pin locations.
7. Install the coolant hoses; then add the appropriate
mixture of coolant until the appropriate level is
reached (see Fuel/Lubrication/Cooling).
8. If removed, install the muffler, exhaust pipe, and
right-side inner splash panel.
9. If drained, add the appropriate engine oil until the
correct level has been reached.
CAUTION
Only apply pressure to the center race of the seal while
installing to avoid damaging the seal.
CAUTION
It is critical while pressing the seal into position to
press on the outer diameter of the seal to avoid damag-
ing the mechanical seal.
