139
TA065A
7. Install the shift drum gear onto the shift drum align-
ing the appropriate splines of the drum with the gear.
8. Install the shift shaft gear onto the shift shaft with the
timing marks facing up; then install into the case
with the gear aligning with the shift drum gear.
TA066A
NOTE: Rotate the shift drum and the shift shaft to
ensure the timing marks are correctly aligned.
9. Install the star detent over the shift drum aligning the
appropriate splines of the detent with the shaft
splines and the dot facing up.
TA134A
10. Install an appropriate bearing seal protector tool onto
the bearing of the output shaft.
TA067
11. Apply a coat of Loctite #5699 to the case; then
ensuring the shift shaft (O-ring lightly coated with
grease) and shift rail are correctly seated, install the
cover.
TA068
NOTE: It will be necessary to tap the cover onto the
case using a rubber mallet. Ensure the alignment pins
are properly oriented.
12. Secure the cover with the cap screws and tighten to
20 ft-lb.
13. Install the detent (gold plug) with spring and O-ring.
Tighten to 20 ft-lb.
TA012A
14. Install the gear position switch. Secure with the wave
washer and snap ring.
15. Install the bell crank being sure to correctly align the
splines of the bell crank and shift shaft and secure
with a new lock nut. Tighten to 15 ft-lb.
