87
CD469
25. Using a flat-blade screwdriver, rotate the adjuster
screw inside the tensioner counterclockwise until all
tension is released; then install the cap screw into the
end of the chain tensioner.
CD470
CD471
26. Loosen the four adjuster screw jam nuts; then loosen
the four adjuster screws on the rocker arms in the
valve cover.
CC005D
27. Apply a thin coat of Three Bond Sealant to the mat-
ing surfaces of the cylinder head and valve cover.
CC275D
28. Place the valve cover into position.
NOTE: At this point, the rocker arms and adjuster
screws must not have pressure on them.
29. Install the four top side cap screws with rubber wash-
ers; then install the remaining cap screws. Tighten
only until snug.
CC003D
30. In a crisscross pattern starting from the center and
working outward, tighten the cap screws (from step
29) to 8.5 ft-lb.
31. Adjust valve/tappet clearance (see Periodic Mainte-
nance).
32. Place the two tappet covers into position making sure
the proper cap screws are with the proper cover.
Tighten to 8.5 ft lb.