72
FI645
11. Install the secondary output driveshaft assembly into
the crankcase half making sure the front and rear
bearing alignment pins are seated in the recesses;
then install the center carrier bearing alignment
C-ring.
FI660A
FI659A
FI661A
Joining Crankcase
Halves
1. Verify that the two alignment pins (A) are in place
and that both case halves are clean and grease free.
Apply Loctite #5900 or suitable substitute sealant to
the mating surfaces. Place the right-side half onto the
left-side half.
FI639B
NOTE: Be sure to apply silicone to the inside
radius of all cap screw locations and the entire
surface of the internal cap screw bosses.
FI639D
2. Using a plastic mallet, lightly tap the case halves
together until cap screws can be installed.
3. From the right side, install the crankcase cap screws
noting the location of the different-sized cap screws;
then tighten only until snug.
NOTE: Rotate the shafts back and forth to ensure
no binding or sticking occurs while tightening the
cap screws.
