11
XR060
3. Add coolant as necessary; then install the radiator
cap and access plug.
NOTE: Use a good quality, biodegradable gly-
col-based, automotive-type antifreeze.
Front Differential/Rear
Drive Lubricant
When changing the lubricant, use approved SAE 80W-90
hypoid gear lube.
To check lubricant, remove the fill plug; the lubricant
level should be 1 in. below the threads of the plug. If low,
add SAE approved 80W-90 hypoid gear lubricant as nec-
essary.
To change the lubricant, use the following procedure.
1. Place the ATV on level ground.
2. Remove each oil filler plug.
3. Drain the oil into a drain pan by removing in turn the
drain plug from each.
XR019A
XR017A
4. After all the oil has been drained, install the drain
plugs and tighten securely.
5. Pour recommended oil into each filler hole.
XR022A
NOTE: Arctic Cat recommends the use of genuine
Arctic Cat lubricants.
6. Install the filler plugs.
! WARNING
Never check the coolant level when the engine is hot or
the cooling system is under pressure.
CAUTION
After operating the ATV for the initial 5-10 minutes, stop the
engine, allow the engine to cool down, and check the coolant
level. Add coolant as necessary.
CAUTION
Any lubricant used in place of the recommended gear
lube could result in premature failure of the shock lim-
iter. Do not use any lubricant containing graphite or
molybdenum additives or other friction-modified lubri-
cants as these may cause severe damage to shock lim-
iter components.
CAUTION
Inspect the oil for any signs of metal filings or water. If
found, take the ATV to an authorized Arctic Cat ATV
dealer for servicing.
Front
