24
KC309A
2. Grasp the end and remove the cap screw, plug, and
end cap.
INSPECTING
1. Inspect the grip for wear, cuts, or cracks.
2. Inspect the grip for deterioration.
3. If a grip is damaged, cut the grip lengthwise using a
sharp knife or box cutter; then peel off the grip.
INSTALLING
NOTE: Before installing a grip, use contact removal
spray or alcohol to clean the handlebar of glue resi-
due, oil, or any other contaminant.
1. Apply a liberal amount of Handlebar Grip Adhesive
to the inside of a new grip.
2. Slide the grip onto the handlebar until it is fully
seated with the smooth part of the grip facing up.
3. Wipe off any excess glue; then secure the grip with
the handlebar end-cap.
Throttle Control
REMOVING
1. Remove the two machine screws securing the throt-
tle control to the handlebar.
2. Slide the grommet out of the lower half of the throt-
tle control; then remove the cable from the actuator
arm.
AF676D
3. Remove the cap screw, lock washer, and washer
securing the actuator arm to the throttle control lever.
AF677D
4. Remove the actuator arm and account for a bushing.
Note the position of the return spring for installing
purposes.
AF678D
INSTALLING
1. Place the return spring into the throttle control; then
place the bushing and actuator arm into position.
Secure with the cap screw, lock washer, and washer.
