2-10
CD714A
Shift Lever
CHECKING ADJUSTMENT
CF130B
Stop the ATV completely and shift the transmission into
the R position. The reverse gear indicator light should be
illuminated.
If the reverse light does not illuminate when shifted to
the reverse position, the switch may be faulty, the fuse
may be blown, the bulb may be faulty, a connection may
be loose or corroded, or the lever may need adjusting. To
adjust, proceed to Adjusting Shift Lever.
ADJUSTING SHIFT LEVER
1. Remove the seat; then remove the left-side engine
cover.
2. With the ignition switch in the ON position, loosen
jam nut (A) (left-hand threads); then loosen jam nut
(C) and with the shift lever in the reverse position,
adjust the coupler (B) until the transmission is in
reverse and the (R) icon appears on the LCD.
CF258A
3. Tighten the jam nuts securely; then shift the trans-
mission to each position and verify correct adjust-
ment.
4. Install the left-side engine cover and seat making
sure the seat locks securely in place.
NOTE: An E (Error) in the gear position icon indi-
cates no signal or a poor ground wire connection in
the circuit. Troubleshoot the harness connectors,
gear position switch connector, gear position switch,
and LCD connector.
Hydraulic Brake Systems
CHECKING/BLEEDING
The hydraulic brake systems have been filled and bled at
the factory. To check and/or bleed a hydraulic brake sys-
tem, use the following procedure.
1. With the master cylinder in a level position, check
the fluid level in the reservoir. On the hand brake if
the level in the reservoir is adequate, the sight glass
will appear dark. If the level is low, the sight glass
will appear clear. On the auxiliary brake, the level
must be between the MIN and MAX lines on the res-
ervoir.
738-420A
! WARNING
Never shift the ATV into reverse gear when the ATV is
moving as it could cause the ATV to stop suddenly
throwing the operator from the ATV.
FOR ARCTIC CAT ATV DISCOUNT PARTS CALL 606-678-9623 OR 606-561-4983
www.mymowerparts.com
