2-8
CF142A
7. Add coolant as necessary; then install the radiator
cap, splash guard (if applicable), and access panel or
snorkel housing.
NOTE: Use a good quality, biodegradable gly-
col-based, automotive-type antifreeze.
Front Differential/Rear
Drive Lubricant
When changing the lubricant, use approved SAE 80W-90
hypoid gear lube.
To check lubricant, remove the fill plug; the lubricant
level should be 1 in. below the threads of the plug. If low,
add SAE approved 80W-90 hypoid gear lubricant as nec-
essary.
To change the lubricant, use the following procedure.
1. Place the ATV on level ground.
2. Remove each fill plug.
AL677C
3. Drain the lubricant into a drain pan by removing in
turn the drain plug from each.
ATV0082A
737-651B
4. After all the lubricant has been drained, install the
drain plugs and tighten to 45 in.-lb.
5. Pour the appropriate amount of approved SAE
80W-90 hypoid gear lubricant into the filler hole.
NOTE: If the differential/rear drive lubricant is con-
taminated with water, inspect the drain plug, fill plug,
and/or bladder.
6. Install the fill plugs; then tighten to 16 ft-lb.
! WARNING
Never check the coolant level when the engine is hot or
the cooling system is under pressure.
CAUTION
After operating the ATV for the initial 5-10 minutes, stop
the engine, allow the engine to cool down, and check
the coolant level. Add coolant as necessary.
CAUTION
Any lubricant used in place of the recommended gear
lube could result in premature failure of the shock lim-
iter. Do not use any lubricant containing graphite or
molybdenum additives or other friction-modified lubri-
cants as these may cause severe damage to shock lim-
iter components.
CAUTION
Water entering the outer end of the axle will not be able
to enter the rear drive unless the seals are damaged.
FOR ARCTIC CAT ATV DISCOUNT PARTS CALL 606-678-9623 OR 606-561-4983
www.mymowerparts.com
