72-DVT30N-2
26
LOG PLACEMENT
The Archgard pan burner and fiber logs are designed to give a realistic fire package, and are
created to look the same as the day they were originally installed. Care must be given when
first installing the logs, and if removed for servicing, as they can be damaged or broken if not
handled properly.
After opening the log set package, inspect the logs to ensure that no damage has occurred in-
side the package. Please report any damage immediately to your Authorized Archgard Dealer.
Gas and vent connections must be made before installing the logs and embers on the pan
burner.
NOTE: Improper placement of logs and/or embers may cause sooting on the internal parts and
glass, and will not be covered under warranty. Do not use broken or damaged logs.
WARNING
:
Failure to position the parts in accordance with these diagrams or failure to use on-
ly parts specifically approved with this appliance may result in property damage or
personal injury.
The pan burner has pins and rests to accept the logs. Locate the grate and embers and place
them on the pan burner as shown. Refer to the pictured instructions on the following pages that
will show how to place the logs. The bottom of each log has a 1 or 4 digit code that can be used
as a reference to help locate the correct log.
IMPORTANT
: Pins & holes must be aligned with logs & burner.
NOTE:
Installing the fiber logs in any other position other than shown will result in flame
impingement causing sooting of the logs, brick liner and ceramic glass viewing area.
Locator Pins
LOG RESTS
LOCATOR PINS
