ARCA AIRPELLET, Technical Manual

Page: 6 / 61

1.1 Norms and declarations of conformity
1.1 Laws
Our factory declares that the stove is
conforming to the following norms and
European directives ok CE marking.
89/336 and 2004/108/CE, EMC directive and
following amendments.
2006/42/CE, Machinery Directive,
89/106/CE, Product for Construction.
EN 60335-1, EN 50165, EN 50366, EN
55014-1, EN 61000-3-2, En 61000-3, EN
14785
The installation of appliances has to comply
the local and national legislation and the
European directives.
Responsibility
The manufacturer won't accept direct or
indirect responsibility, civil or penal derived
from:
an insufficient maintenance;
not observation of the instructions
contemplated in the present training manual.
an use of this appliance ont allowes by the
Country of destination;
the installation from personal unqualified or
without the pertinent formation.
the changes and reparations not authorized
from the manufacturer.
the employment of non original spare parts
non original.
The use of pellet not approved by the
manufacturer.
1.2 Installation
Chimney of exhaust gas
To prevent malfunction of the product is
critical to have a chimney installed in a
workmanlike manner and use a good quality
pellet.
The chimney of exhaust gas must comply the
followings requisite:
š
It shouldn’t be connected to any other
type of fireplace, stove, boiler or bell of
ventilation (fig 1).
š
It has to be installed to a distance adjusted
from where material fuel there is or
inflammable through a hollow of air or
opportune isolation.
š
The inside section will have to be uniform,
preferably circular: the square or
rectangular sections should have angles
rounded off with a greater ray of 20 mms,
a maximum relationship among the sides
of 1,5; the walls have to be the smoothest
possible not to have particularly narrow
zones, irregular curves or discontinuity or
deviations from the superior axle to the
45°.
fig. 1: methods to install the exaust gas ducts
6