ARANA FOGATTI FS06B1, Installation And Operating Instructions Manual

Page: 45 / 68

Make A Difference 卓 / 尔 / 不 / 凡
EN
45
4.4 Installation steps
Flat lock Ignition pin
Decorative ring Water flow sensor
Fixing plate Drain pipe
Front panel Water inlet temp probe
Blind flange Relief valve
Fan Volute Gas inlet assembly
Housing nether plate
Controller
Housing upper plate
Connecting pipe
for burner and valve
Heat exchanger
ON/OFF switch
Wind pressure switch
Gas proportional valve
Water outlet temp probe
Select the installation location on the RV before installation.
Fuse Box
Anti-freezing thermostat
Wire controller
Thermostat
Anti-dust mesh
Water inlet pipe
Burner
1 16
2 17
3 18
5 20
15
7
22
4 19
6 21
10
25
11
26
14
13
28
12
27
8
23
9
24
NO. NO. Name Name
Do not install the water heater in the RV aisle.
It should be installed on the exterior wall of the RV.
The exhaust port should face outside the RV.
RV hot water heater should be installed on a solid, or on a non-combustible frame.
In order to install a water heater firmly, the unit's bottom should be supported by a
non-combustible floor or frame.
If the surrounding of the opening is a combustible material, use a flame-retardant
insulating material such as heat-insulating felt or heat-insulating board to completely
separate the back surface of the water heater from the combustible surface.
And the minimum thickness of the filling material must be greater than 20mm.