ARANA FOGATTI FS06B1, Installation And Operating Instructions Manual

Page: 46 / 68

EN
46
The housing connection gap behind the water heater should be sealed with a high
temperature sealant during installation to isolate it from the inside of the RV. In this
way, the burning air does not come from the inside of the RV, but from the outside of
the RV and the exhaust gas generated by the combustion is discharged outside the
vehicle.
Cut a hole sizing 330x330 mm.
The opening depth should be sufficient to accommodate the gas pipe, wire, and
water pipe when the water heater is pulled out of the hole.
And at the bottom or back of the hole, please reserve space for gas inlet, inlet, outlet
pipe, power line and other channel holes.
Reserve extra gas pipe, wire, pipe length should be greater than the opening depth
1.5 times for maintenance and testing.
The perimeter of the hole should ensure sufficient strength to fix the water heater.
See FIG.09.
The hole can be strengthened by adding support frames under the water heater
bottom in order to ensure water heater does not make any damage on the wall of
the RV.
Correctly connect the G1/2′′ cold and hot water pipe to the back of the water
heater.
Entrance
09