ARANA FOGATTI FS06B1, Installation And Operating Instructions Manual

Page: 56 / 68

EN
56
Fault alarm release and reset method:
If the above code appears, please check that all moisture is normal, press the on/off
switch or power off to restart.
(when you start and or turn on the water, press the "on/off" switch within 15 minutes
and then press the "on/off" switch 5 times (the fan starts for 5 times), the water heater
will lock and cannot start. After the icon disappears or it waits for 15 minutes, it can be
automatically unlocked (reset). The water heater returns to normal use. If the above
operations cannot be returned to normal use, please inform the after-sales service
personnel.
When the outdoor temperature is too low, the exhausted smoke
encounters outdoor cold air and condenses into a white mist.
The inlet water temperature is too low and the water flow
exceeds the heating capacity of the water heater.
Please adjust the amount of water appropriately.
If the water flow is too low, the water will become cold. A
minimum water flow of 1 gallon per minute is required to ensure
the stable operation of the water heater.
In order to prevent oxygen deprivation, some models have 20
or 40-minute timing protection. Please turn off the tap and use
it after a while.
This is the function of delaying the shutdown of the fan, in order
to completely discharge the exhaust gas of the water heater to
ensure the safety of the user.
White smoke at
exhaust
It is not a failure when the following conditions occur:
Water is not
heating
Water not hot
enough
After 20 minutes
or 40 minutes,
the water heater
suddenly goes out
Close the hot water
valve, but the
fan cannot stop
immediately
Example Reason and handling method