ARAG Explorer 46701801, Installation, Use And Maintenance Manual

Page: 16 / 60

16
MODE
GB
SWITCHING ON
• Starting the device
First, the
L2
LED (Fig. 12 ) indicates that the device is operating.
1 repeated flash of
L2
LED: start in A-NET mode.
2 repeated flashes of
L2
LED: start in ISOBUS mode.
• Operation test
Once the device has started, the joystick runs an operation test in the following manner:
simultaneous illumination of all LEDs, backlit keyboard and 1 long vibration.
The device enters the “Main” page functions and triggers the following signals.
Refer to the “Signals: LEDs and vibrations” paragraph for your mode.
SIGNALS: LEDS AND VIBRATIONS - A-NET MODE
Fig. 12
• Press active keys
The device vibrates (1 short vibration) when any button is pressed.
LED no. LED STATUS VIBRATION
L1: PAGES 1 / 1 bis
L1
- steady on : page 1 ONLINE 1 vib 1 pause
- consistent flashing : page 1 bis ONLINE 1 vib 1 pause
- off : Main page ONLINE none
- off : page 2 ONLINE 2 vibr 1 pause
L2: ALARM LEDs
L2
- off : no error none
- 1 periodical flash : CANBUS communication error none
- 2 periodical flashes : the monitor has not correctly configured the joystick none
- 3 periodical flashes : hardware error [03] none
- 4 periodical flashes : supply voltage too high none
- 5 periodical flashes : supply voltage too low none
- 6 periodical flashes : hardware error [06] none
- 7 periodical flashes : hardware error [07] none
- fast regular flashing : signal managed by the connected monitor 1 long vib 1 pause
L3: PAGE 2
L3
- steady on : page 2 ONLINE 2 vibr 1 pause
- off : Main page ONLINE none
-
off
: page 1 / 1 bis ONLINE 1 vib 1 pause
L4: CENTRAL BUTTON STATUS
L4
- steady on : associated function ON none
- off : associated function OFF none
LEGEND:
- consistent flashing = constant flashing
- periodical flashing = set of several flashes separated by pauses