This kit is designed to update a 4500 or 5000 Series English Mark Dart Game to a 6300 Series
(Super 6 Plus II). It will add the monitor and light shadow box to your game. The appearance of
your game, after the kit is installed, is similar to our 6000 to 6300 Series.
Tools required:
Hammer, Phillips and Straight Blade Screw Driver,
Drill Bits, Wire Stripper,
Solder Wick, Pry Bar, Adjustable Wrench, Saber (Jig) Saw, Soldering Iron, Channel Lock Pliers,
Electric Drill, Wire Cutters, Solder.
STEP
SEPARATE THE UPPER CABINET AND THE LOWER CABINET, AND STRIP OUT
THE OLD COMPONENTS.
Remove the four (2 each side) carriage bolts that connect the upper cabinet to the lower cabinet.
Disconnect the coin door harness before disassembly. Remove the upper cabinet. The top light as-
sembly must be removed from the upper cabinet; it will not be reused. Unplug the dart head pig-
tails and remove it temporarily.
Remove the following items (they are not reused):
Web (if an Arachnid Web Kit has been added.)
Plexiglass Front Panel
Power Supply
Main PC Board
Main Wire Harness
Light Receptacle (Top Light Plug)
Target Interface Board (4500)
On/Off Switch (5000)
Inner Door w/Light PC Board & Target Interface Board (5000)
On the lower cabinet remove the Competitor strip and plexiglass instruction panel on 5000.
CAN
OFF WITHOUT MAKING CUTS
FIGURE 1
FRONT VIEW
FIGURE 2
STEP
CABINET MODIFICATIONS
(See Figure 1) Cut and remove the remaining lower front support panel from the upper cabinet.
(See Figure 2) Cut away a portion of the upper cabinet bottom.
(See Figure 3) Cut and remove the lower cabinet as shown and remove the support block under-
neath it.
Using the hammer and pry bar, clean out the remaining 2” of the instruction panel. Be careful not
to damage the rest of the cabinet.
