STEP
ASSEMBLY
Figure
12)
Remove backing on foil and place it above pilot holes in cabinet. Be careful not to
cover lamp shield channels or the vent slot in the top panel, then screw down lamp socket. Repeat
procedure for the other lamp assemblies.
Figure
13)
Drill
holes as close to the sides as possible and in the approximate location
of the lamp sockets. Run the black and white wire from the socket through the black tube then
through the
drilled holes to the back of the cabinet.
The enclosed wire splices are used by placing stripped wires in and crushing with channel lock
pliers.
The lamp harness has three stripped wires held together with a wire tie. Using a splice, attach
the black wires to the black wire from the right lamp socket. Do the same for the white wires.
The remaining wires are for the other lamps. Match white wires with white and black with black
Screw in light bulbs and put shield on. The lamp harness can then be plugged into matching con-
nector on main harness.
PILOT
LIGHT SHIELD
CHANNELS
FIGURE 12
GRAY WIRE
i
2 2 ”
. - - -
8”
FIGURE 13
STEP
WEB DART ASSEMBLY
NOTE: DO NOT attach threaded rod before web is put in place.
Put the web in place and add the threaded rod from behind. Thread nut onto threaded rod to hold
web in place.
