INSTALLATION INSTRUCTIONS FOR
DOUBLE BULLSEYE ALL GAMES
Your Double Bullseye Accessory Kit should contain the following items:
1.
Inner Bull (Black)
2.
Outer Bull (Red)
3.
Decal
(4. New Switch Matrix (Matrix is already installed on new double bull games)
Carefully remove the dart head from your dart game by removing the 4 bolts holding the dart
head in the game. Lay the dart head flat on a table, with the white backboard facing you.
HINT: Before removin
the heads of the screws
the eight nuts holding the dart head together, place a piece of tape on
segment side of dart head) to hold them in place after nuts are removed.
Refer to your game parts manual for illustrations on how this disassembly process is done.
Disassemble and reassemble dart head as follows:
a) Remove the 8 nuts holding the target back to the spider.
b) Remove the switch matrix.
c) Remove white molded matrix cushion (older dart heads use a clear vinyl gasket and a red rub-
ber damper)
d) Check for dirt and broken tips between spider and cups. Install new double bullseye.
e) Clean and reinstall matrix cushion. The smooth side of the cushion comes in contact with the
segments.
IMPORTANT
THERE
SHOULD BE A SMALL U SHAPE CUTOUT ON THIS CUSHION. POSITION IT TO
THE
OF THE CENTER LOCATION HOLE AT THE
SEGMENT ON THE SPIDER
(BEHIND THE “DOUBLE 1” SEGMENT).
kit includes a new Switch Matrix, install it with the tails on the left and the 9 pin con-
nector on top. Store the old Matrix in a safe place. Ifyourkit does not contain a new Matrix, simp-
ly reinstall the old one in the same manner.
g) Clean and reinstall target back
and 8 nuts, tighten only finger tight.
N O T E
BOLTS MUST BE FINGER TIGHT ONLY. ANY TIGHTER COULD CLOSE CONTACTS IN
THE MATRIX AND CAUSE INACCURATE SCORINGORNO SCORING AT ALL.
NOTE
MENTS AS THIS CAN CAUSE NON-SCORING OR IMPROPER SCORING. ON A HEAVILY
PLAY-EDGAMEITISAGOODIDEATODOPREVENTIVEMAINTENANCEONAREGULAR
BLING. THIS CAN HELP PREVENT SERVICE CALLS IN BETWEEN REGULAR VISITS.
