Visage™ Digital Installation Guide 19
Place the rail end caps into both brackets and push firmly
into position.
17
Ensuring the hose washer is in the correct position; attach the hose to the wall outlet or the
bottom of the exposed rail.
18
Run the shower for a few seconds to clear any debris and to check for any leaks.
Pass the hose through the gel hook.
19
Current Water Supply Regulations state that the handset should not be allowed to pass
a point 25mm above the spill over level of the bath or shower tray. If this cannot be
achieved, the hose must be passed through the gel hook which has been designed to be
utilised as a hose restraint.
Disengage the pivot clip and remove the pivot from the bottom
of the handset. Ensure the hose washer is in the correct position
and screw the pivot into the hose, using a suitable hexagonal key to
tighten, taking care not to over-tighten. Reinsert the pivot into the
handset and engaged the pivot clip prior to placing the handset into
the Pinch Grip™ holder.
20
Slide the rail assembly up through the top rail bracket.
15
Align the fixing hole of the bottom bracket with the corresponding holes on the rail assembly,
ensuring the smaller sized hole on the rail is closest to the wall. Secure the bottom rail bracket
to the wall using the long wall screw.
16
